Buy Dlink DWL-2600AP Wireless Access Point from our D-Link Shop, Nairobi Kenya
The Dlink DWL-2600AP is an entry level indoor access point designed to enable businesses to deploy low cost managed wireless networks. It can work in standalone mode for initial deployment and then complemented by adding a D-Link Unified Wireless Switch or Controller to provide centralised wireless LAN management.
Specifications
Type | Hardware-managed AP |
---|---|
Wireless standard | Wireless N |
Frequency band mode | Single-band |
Wireless speed | 300 Mbps 2.4 GHz |
Antenna type | Embedded omni-directional antennas |
Antenna gain | 3 dBi for 2.4 GHz |
Power-over-Ethernet | Yes |
Wired interface | 1 x Fast Ethernet LAN |
Console port | |
Indoor/outdoor | Indoor |
Type of housing | Plastic |
Wireless modes | Access Point (AP) WDS bridge WDS with AP |
Advanced features | MIMO |
Maximum number of SSIDs | 16 |
Auto channel selection | |
WMM-PS/802.11e (U-APSD) | |
Wi-Fi scheduler | |
AP traffic load balance | |
L2 roaming | |
WPA/WPA2-Personal/Enterprise | |
TKIP/AES encryption | |
WPA_WPA2_PSK over WDS | |
WLAN partition | |
SSID broadcast disable | |
Rogue AP detection | |
Station isolation | |
MAC address filtering | |
802.1X authentication | |
Controller managed features | AP load balance Auto-channel, auto-RF management Captive portal L2/L3 fast roaming Rogue AP mitigation View neighbour AP information WIDS/WIPS |
Supported D-Link Wireless Controllers/Unified Switches | DWC-1000 DWC-2000 DWS-3160 DWS-4026 |
Management platform | Hardware controller: DWC/DWS Series |
WEB | |
SNMP (v1, v2c, v3) | |
CLI | |
Telnet | |
SSH | |
Syslog | |
Central management (through AP Manager II and/or D-View Wireless Control Module) | |
Configuration group sync through AP Array (up to 8 APs) | |